#49222: Problems upgrading root6 (after installation step) --------------------------------+--------------------- Reporter: graziosi.angelo@… | Owner: mojca@… Type: defect | Status: new Priority: Normal | Milestone: Component: ports | Version: Resolution: | Keywords: Port: root6 | --------------------------------+--------------------- Comment (by mojca@…): I can try to explain, but if you are ok asking again on the list, I would suggest you to do so as you might get better answers there (and there might be other users experiencing the same problem). 0.) In my opinion the best temporary solution would be to deactivate the latest root installation and activate the previous working version. I don't think there have been any dramatic changes. You just need to remember to upgrade it again when upgrades start working. 1.) You have to either * create a local repository, see https://guide.macports.org/chunked/development.local-repositories.html * or patch `/opt/local/var/macports/sources/rsync.macports.org/release/tarballs/ports/science/root6/Portfile` (this might be easier in the short run, you just need to be aware that the changes will be gone by the next time you run selfupgrade) 2.) You need a patched version of the `Portfile`. At some temporary place run {{{ svn co https://svn.macports.org/repository/macports/trunk/dports/science/root6 }}} and take the `Portfile` that you get (either overwrite the file in MacPorts or place it in your local repository). 3.) Run `portindex`, the `port outdated` should show you `root6` and then `sudo port upgrade root6`. (Don't forget to either update or remove the file from local repository after a while.) -- Ticket URL: <https://trac.macports.org/ticket/49222#comment:4> MacPorts <https://www.macports.org/> Ports system for OS X