-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA512 markd@macports.org wrote:
Simon Ruderich <simon@ruderich.com> writes:
Just if anybody else is trying to do this. I figured it out and it works with the following command:
./configure --prefix=NEW_PREFIX --with-tclpackage=NEW_TCLPATH
NEW_PREFIX must be different then /opt/local (if you used the default install) and NEW_TCLPATH must differ from /Library/Tcl.
Also be sure to use $PATH without /opt/local/bin (default install) or ./configure will fail. I think the best is the default path:
PATH=/bin:/sbin:/usr/bin:/usr/sbin
Is this worth writing a FAQ entry for?
Mark
I think so. Even if it's useless for normal users but developers will benefit of this. To test a new Portfile it's best to try it on a clean system but normally I don't want to remove all my installed ports for this, so an own port installations is handy. It cost me some time figure it out even if it's real simple. So I think a FAQ entry would be good. Thanks, Simon - -- + privacy is necessary + using http://gnupg.org + public key id: 0x6115F804EFB33229 -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.7 (Darwin) iD8DBQFGvIcOYRX4BO+zMikRCip6AJ47QTD45ynLZC36pVVNNXHxTg4sMACgrMUW 4cNn8rrMwROUhkHR/0tJM8Q= =Viyc -----END PGP SIGNATURE-----