Possible.  Did not know that command.  I had been gone for some time.
What I did to get around it was I did:

Export EDITOR=vi
Sudo port edit xmlto

I then changed all the checksums to the destination checksum and it seem to work, but not sure if that is safe to do?

If I encounter this issue again I will try your way.

Thanks again.


On 9/22/07 9:04 AM, "N_Ox" <n.oxyde@gmail.com> wrote:

Le 21 sept. 07 à 18:58, Marcos Rivera a écrit :

> Hello,
>
> I am new to mcports and was attempting to install Gimp.
> I have xcodetools installed and it got part way through until it
> his xmlto
> Below is error I received when trying to install just xmlto
>
> $ sudo port install xmlto
> Password:
> --->  Verifying checksum(s) for xmlto
> Error: Checksum (md5) mismatch for xmlto-0.0.18.tar.bz2
> Error: Target org.macports.checksum returned: Unable to verify file
> checksums
> Error: Status 1 encountered during processing.
> david:~/Desktop/xmlto-0.0.18 mrivera$ sudo port sync
> david:~/Desktop/xmlto-0.0.18 mrivera$ sudo port install xmlto
> --->  Verifying checksum(s) for xmlto
> Error: Checksum (md5) mismatch for xmlto-0.0.18.tar.bz2
> Error: Target org.macports.checksum returned: Unable to verify file
> checksums
> Error: Status 1 encountered during processing.
>
>
> Any help is greatly appreciated.
> Thank you
> Marcos
>

It works here, the fetch must have gone wrong and you ended up with a
corrupted tarball.
Try:
        sudo port clean --all xmlto
        sudo port install xmlto

Hope this will help,
Regards,

--
Anthony Ramine, the infamous MacPorts Trac slave.
nox@macports.org